Related Manuals for Winco WC10000VE-G
Summary of Contents for Winco WC10000VE-G
- Page 1 WC10000VE/E-G GENERATOR INSTALLATION AND OPERATORS MANUAL WINCO INC. 225 S. CORDOVA AVE. LE CENTER, MN 56057 507-357-6821 SERVICE DEPT. 507-357-6831 www.wincogen.com...
-
Page 2: Table Of Contents
Should you experience a problem please follow the “Troubleshooting GENERATOR CONNECTIONS Tables” near the end of this manual. The warranty listed in the manual STARTING ELECTRIC MOTORS describes what you can expect from WINCO should you need service PREPARING THE UNIT assistance in the future. UNPACKING... -
Page 3: Engine
ENGINE B. Keep fuel containers out of reach of children. C. Do not smoke or use open flame near the generator set or fuel tank. Engine Manufacturer Briggs & Stratton D. Keep a fire extinguisher nearby and know its proper use. Engine Model Number 543477 Fire extinguishers rated ABC by NFPA are appropriate. -
Page 4: Testing Policy
TESTING POLICY of this generator. Up to 4,800 watts at 120 volts (40 Amps) can be drawn from the receptacles attached to either A or B output legs. This generator is capable of producing 40 Amps of 240 volt current at C. Before any generator is shipped from the factory, it is fully checked Check the appliance or tool nameplates for the current and voltage to for performance. -
Page 5: Preparing The Unit
WINCO take care of the freight claim. If you sign for the unit, the requirements. transfer of the ownership requires that you file the freight claim 2. -
Page 6: Conserv-R ® Idle Control
See the engine manual for special instruction for operating this unit at over 5000 feet. ® CONSERV-R IDLE CONTROL The automatic Conserv-R ® idle control is a gas saving, solid state system, designed to reduce engine speed whenever the electrical load is removed from the generator. -
Page 7: Initial Start Up
INITIAL START UP 6. When the engine starts, open the choke INITIAL START UP gradually. 2. Turn on the fuel supply. Ref “A”. 7. The engine should promptly come up to The throttle control on these generators is preset 3. Engage the choke (“B”) by pulling it out. A warm engine operating speed. -
Page 8: Connecting The Loads
OPERATING SPEED to it. Running the engine at excessively high speeds results in high voltage, which may significantly shorten the life of appliances being The engine-generator must be run at the correct speed in order to used. produce the proper electrical voltage and frequency. Output voltage should be checked periodically to ensure continued CAUTION: EQUIPMENT DAMAGE proper operation of the generating plant and appliances. -
Page 9: Wiring
WARNING: PERSONAL DANGER panel. Keep in mind only a limited amount of amperage is available DO NOT OPERATE THIS GENERATOR INDOORS, The unit should from the generator set. Some circuit breakers may still have to be turned off to prevent an overload on the generator during the initial be stored in a warm, dry location. -
Page 10: Generator Care
A. Start the engine and warm it up, stop the engine and remove the spark plug wire to prevent it from accidentally being started. NOTE: Do NOT use pressurized air or solvents to clean the filter. B. This engine has an oil drain valve for your convenience. Attach a Pressurized air can damage the filter and solvents will disolve the filter. -
Page 11: Cleaning
TROUBLESHOOTING CLEANING Problem Possible Causes Remove dirt and debris with a cloth or brush. DO NOT use high Won’t start Low oil level pressure spray to clean either the engine or the generator. The high Fouled spark plug pressure spray could contaminate the fuel system and the generator Out of fuel components. -
Page 12: 24 Month Limited Warranty
WINCO written instructions. WINCO’s sole liability, and Purchaser’s sole remedy for a failure under this warranty, shall be limited to the repair of the product. At WINCO’s option, material found to be defective in material or workmanship under normal use and service will be repaired or replaced.
Need help?
Do you have a question about the WC10000VE-G and is the answer not in the manual?
Questions and answers