Subscribe to Our Youtube Channel
Related Manuals for Winco WT3000H
Summary of Contents for Winco WT3000H
- Page 1 INDUSTRIAL PORTABLE INSTALLATION AND OPERATORS MANUAL WT3000H WC5000H WC6000H WC6000HE WINCO INC. 225 S. CORDOVA AVE. LECENTER, MN 56057 507-357-6821 SERVICE DEPT. 507-357-6831 1204-00 60706-221...
-
Page 2: Using The Manual
Should you experience a problem please follow the “Troubleshooting Tables” near the end of this manual. The warranty listed in the manual describes UNIT SPECIFICATIONS what you can expect from WINCO should you need service assistance in the future. GENERATOR MODEL WT3000H Surge Watts... -
Page 3: Safety Information
SAFETY INFORMATION 2. FIRE HAZARD Gasoline and other fuels pres- ent a hazard of possible explosion and/or fi re. This engine generator set has been designed and a. Do not refuel when the engine is running or manufactured to allow safe, reliable performance. hot. -
Page 4: Testing Policy
Rated output of generator is based on engineering tests of typical units, and is subject to, and limited WT3000H: This generator is designed for 120 volt by, the temperature, altitude, fuel, and other condi- alternating current (AC) use only. Two duplex outlets tions specifi... -
Page 5: Starting Electric Motors
STARTING ELECTRIC MOTORS The heavy surge of current required for starting motors is required for only an instant. The genera- tor will not be damaged if it can bring the motor up Electric motors require much more current (amps) to to speed in a few seconds of time. -
Page 6: Optional Dolly Kit
Units equipped with a recoil or All WINCO Industrial generators are equipped rope start will operate satisfactorily without a battery. standard with low oil shutdown systems. The Honda A twelve volt battery, BCI group U1 rated at 235 engines all use a fl... -
Page 7: Initial Start-Up
occur during operation, the fl oat will ground out the CAUTION: EQUIPMENT DAMAGE magneto impulse, “killing” the engine. To get the engine started, you must add the required amount of When using these generators to power a home oil to the engine crankcase. Use of the fl oat system or construction trailer the Conserver®... -
Page 8: Starting Hints
minimizes the drain on the battery and improves the c. While the engine is warm, drain the oil and refi ll possibility of starting under such adverse conditions. with fresh oil. Always keep the battery charged, especially during d. Remove the spark plug, pour approximately 1/2 cold weather operation. -
Page 9: Connecting The Loads
The speed of the engine was carefully adjusted at will automatically adjust itself to the load. No harm the factory so that the generator produces the proper to the generator will result if it is operated with no voltage and frequency. For normal usage, the speed load connected. -
Page 10: Engine Care
Fill to the “FULL” mark on the dipstick. be installed, such as the Emergency Transfer/Service (ET/S) system available through your WINCO dealer. 3. Cartridge Air Cleaner: Remove and clean The emergency distribution panel must be installed... -
Page 11: Troubleshooting Hints
Reassemble cover and screw down tight. Replace cooling. At least yearly remove the blower housing the cartridge included with Dual Element Air Cleaner on the engine and clean the chaff and dirt out of the yearly or every 100 hours. Service more often if engine cooling fi... - Page 12 WINCO’s sole liability, and Purchaser’s sole remedy for a failure under this warranty, shall be limited to the repair of the product. At WINCO’s option, material found to be defective in material or workmanship under normal use and service will be repaired or replaced.
Need help?
Do you have a question about the WT3000H and is the answer not in the manual?
Questions and answers