Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Winco WC3000H
Summary of Contents for Winco WC3000H
- Page 1 INDUSTRIAL GENERATORS WC3000H W9500HE OPERATORS MANUAL 60706-128...
-
Page 2: Table Of Contents
COPY YOUR MODEL AND SERIAL NUMBER HERE the operating instructions in this manual. No other WINCO generator has the same serial number as Should you experience a problem please follow the yours. It is important that you record the number and other “Things To Check”... -
Page 3: Features By Model Table
60706-128 Page 1 WINCO PORTABLE SERIES... -
Page 4: Guide To Product Safety
The refueling. installation must comply with all national, state, Keep fuel containers out of reach of children. and local codes. Do not smoke or use open flame near the generator set or fuel tank. WINCO PORTABLE SERIES Page 2 60706-128... -
Page 5: Basic Information Intended Uses
Hz (Hertz), AC (Alternating Current). the motor. The WINCO Industrial series generators have the EXTRA Self-excited generators respond to severe overloading Heavy FULL POWER winding to allow the use of all the differently than the power line. -
Page 6: Preparing The Unit
DO NOT use gasoline containing intended to be used as a battery charger. methanol. Always insure that the fuel is clean and free of all impurities. WINCO PORTABLE SERIES Page 4 60706-128... -
Page 7: Low Oil Shutdown
LOW OIL LEVEL SHUTDOWN SYSTEM With the automatic Conserver® switch in the “automatic” All Winco Industrial generators are equipped standard with position, the system operates as follows: low oil shutdown systems. The Honda and Briggs & 1. After the engine has been started, and no electrical Stratton IP engines all use a float switch system. -
Page 8: Basic Operation
Do not operate the starter more than 15 seconds during each minute. Repeat if necessary. When the engine starts, open the choke gradually. The engine should promptly come up to operating speed. WINCO PORTABLE SERIES Page 6 60706-128... -
Page 9: Operating Speed
+/- 2 seconds per minute. recheck the rating of the generator set. Be sure it can handle the intended load and is compatible with the voltage, phase, and current ratings. 60706-128 Page 7 WINCO PORTABLE SERIES... -
Page 10: Engine Care
Emergency Transfer/Service (ET/S) system available whichever occurs first. Service more often if necessary. through your Winco dealer. The emergency distribution Clean by tapping gently on flat surface. If very dirty, replace panel must be installed by a licensed electrician according the cartridge using only original equipment parts available at to all applicable codes. -
Page 11: Generator Care
*Defective receptacle. operator and destructive to the equipment. *No residual magnetism (in generator). *Defective stator. *Defective rotor (field). *Shorted capacitor. *Defective rectifier. *Circuit breaker tripped *Engine RPM below 3600 RPM —————————————————————————— 60706-128 Page 9 WINCO PORTABLE SERIES... -
Page 12: Limited Warranty
WINCO’s sole liability, and Purchaser’s sole remedy for a failure under this warranty, shall be limited to the repair of the product. At WINCO’s option, material found to be defective in material or workmanship under normal use and service will be repaired or replaced. For warranty service, return the product within the warranty period from the date of purchase, transportation charges prepaid, to your nearest WINCO Authorized Service Center or to WINCO, Inc.
Need help?
Do you have a question about the WC3000H and is the answer not in the manual?
Questions and answers