PARTS LIST, PARTS DRAWINGS, AND WIRING DIAGRAM PERTAINING TO YOUR UNIT ARE ENCLOSED WITH THIS MANUAL. This manual covers the latest compact portable tractor driven Power Take Off (PTO) generator model from Winco. This 10,000 watt generator is designed to provide120/240V single phase electrical power for standby and utility ser- vice when commercial power is interrupted, inaccessible or impractical.
SAFETY INFORMATION 4. NOISE HAZARD - Excessive noise is not only tiring, but continual exposure can lead to loss of hearing. This generator set has been designed and manufactured to allow Use hearing protection equipment when working safe, reliable performance. Poor maintenance, improper or care- around this equipment for long periods of time.
DESCRIPTION UNPACKING The WINCO rotating field power take-off generators are de- CAUTION: Equipment Damage signed primarily for hobby/small farm use as a standby electrical DO NOT invert generator during unpacking. The Gearcase con- power supply, utilizing the power take-off of a tractor or truck tains oil which will leak out if inverted during unpacking.
Install shims if necessary to even out the bed under the C. The foundation surface should be flat. starting and reflected load torque during operation. WINCO THREE POINT HITCH mounting pads, then bolt the generator firmly in place. B. The foundation must be solid enough to absorb generator...
ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS DANGER: PERSONAL INJURY IF THE GENERATOR IS TO BE USED AS A STANDBY DANGER: P ERSONAL INJURY POWER SOURCE, A MANUAL TRANSFER SWITCH MUST CAUTION: IF THE GENERATOR IS TO BE USED AS A STANDBY CAUTION: BE INSTALLED TO SEPARATE THE GENERATOR AND THE Only qualified electricians should install electrical wiring.
Page 7
Visually inspect the generator. Check for: your Winco dealer, the part number is “300137”. need additional plugs for multiple sites you can order additional plugs from your Winco dealer, the part number is “300137”. 1. Visually inspect the generator. Check for: Correct mounting...
Page 8
3. With engine idling, engage the power take-off drive. the bar will chatter when rotating, which will cause the age to flicker. Drive shafts shipped new from Winco are al- generator output voltage to flicker. Drive shafts shipped ways synchronized and tethered so they can not be taken 4.
If the generator is mounted on an off-high- that wiring connections are not loose at the generator end, circuit Page 7 trailer, such as the Winco trailer, it should be 0310-00 circuit breakers, and receptacles. way trailer, such as the Winco trailer, it breakers, and receptacles.
SERVICE DIAGNOSIS REMEDY POSSIBLE CAUSE LOW OUTPUT VOLTAGE Low Speed Undersized/overloaded. Check for overload on the tractor or undersized. Defective governor. Check tractor governor. Tight or defective throttle levers and joints. Low power - worn engine. Worn or defective tractor engine (see engine manufacturers check list.) High line loss.
PTO GENERATOR 1 MONTH LIMITED WARRANTY WINCO, Inc., warrants for twelve months from date of shipment, that it will repair or replace at its option, for the original user, the whole or any part of the product found upon examination, by WINCO at its factory at 225 South Cordova Avenue, Le Center, Minnesota, or by any factory- authorized service station, to be defective in material or workmanship under normal standby use.
Need help?
Do you have a question about the W10PTOS/A and is the answer not in the manual?
Questions and answers