Initializing Hdds - HIKVISION DS-7600NI-12 Series User Manual

Table of Contents

Advertisement

13.1 Initializing HDDs

Purpose:
A newly installed hard disk drive (HDD) must be initialized before it can be used with your NVR.
A message box pops up when the NVR starts up if there exits any uninitialized HDD.
Click Yes button to initialize it immediately or you can perform the following steps to initialize the HDD.
Steps:
1. Enter the HDD Information interface.
Menu > HDD> General
2. Select HDD to be initialized.
3. Click the Init button.
4. Select the OK button to start initialization.
Network Video Recorder User Manual
Figure 13. 1 Message Box of Uninitialized HDD
Figure 13. 2 HDD Information Interface
Figure 13. 3 Confirm Initialization
Figure 13. 4 Status changes to Initializing
199

Advertisement

Table of Contents
loading

Table of Contents