Display Transceiver Manuinfo Interface - H3C S3100-52P Command Manual

Command Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Connector Type
Wavelength(nm)
Transfer
distance(xx)
Digital Diagnostic
Monitoring
Vendor Name
Ordering Name

3.1.14 display transceiver manuinfo interface

Syntax
display transceiver manuinfo interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Interface type and interface number.
Field
Type of the connectors of the pluggable transceiver:
Optical connectors, including SC (SC connector,
developed by NTT) and LC (LC connector, 1.25
mm/RJ45 optical connector developed by Lucent).
Other connectors, including RJ-45 and CX4.
Optical transceiver: wavelength of the laser sent is
displayed, in nm. If the transceiver (for example,
10GBASE-LX4
wavelengths, every two wavelength values are separated
by a comma.
Electrical transceiver: N/A is displayed.
Transfer distance, with xx representing km for single-mode
transceivers and m for other transceivers. If the transceiver
supports multiple transfer medium, every two values of the
transfer distance are separated by a comma. The
corresponding transfer medium is included in the bracket
following the transfer distance value. The following are some
of the transfer media:
9 um: 9/125 um single-mode fiber
50 um: 50/125 um multi-mode fiber
62.5 um: 62.5/125 um multi-mode fiber
TP: Twisted pair
CX4: CX4 cable
Whether the digital diagnosis function is supported, where:
YES: supported
NO: not supported
Vendor name or vendor name specified of the transceiver:
Transceiver customized by H3C: H3C is displayed.
Other transceiver: the original vendor name is displayed.
Ordering name of the pluggable transceiver
Chapter 3 Device Management Commands
Description
transceiver)
3-14
supports multiple