Reboot - H3C S3100-52P Command Manual

Command Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Parameters
None
Description
Use the patch run command to place ACTIVE patches to the RUNNING state.
This command is applicable to ACTIVE patches only. After a system reboot, running
patches remain in the RUNNING state and keep working.
Examples
# Load patch file S3600_1510_P001.pat.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] patch load S3600_1510_P001.pat
# Activate the loaded patch.
[Sysname] patch activate
# Place ACTIVE patches into the RUNNING state.
[Sysname] patch run

3.1.19 reboot

Syntax
reboot [ unit unit-id ]
View
User view
Parameters
unit-id: Unit ID of a switch, the value can only be 1.
Description
Use the reboot command to restart a specified Ethernet switch.
Note:
Before rebooting, the system checks whether there is any configuration change. If yes,
it prompts whether or not to proceed. This prevents the system from losing the
configurations in case of shutting down the system without saving the configurations.
Chapter 3 Device Management Commands
3-18