Table of Contents
Advertisement
3
ACCESSORIES
Accessory
KIT X*
NFC FLOATER*
NFC WATER LEVEL MEASUREMENT
SACRIFICIAL ANODE
DOC68
* The minimum overall dimensions of the pump with float inside a well or tank are as follows:
The minimum distance between the end of the pump float and the wall is 3cm (1.18 in) (see figure 10).
The minimum distance between the float of the suction pipe and the wall (in the case of version X) is 10cm (3.94 in) (see figure 10).
The accessories NFC FLOATER and NFC WATER LEVEL MEASUREMENT are installed by inserting them in a special seat without requiring
any electrical connection.
4
FIRST INSTALLATION
The pump and the DCONNECT BOX 2, if present, must be connected to the same power mains, avoiding their being galvanically
separated, as for example due to the presence of open isolation transformers or switches, even single-phase ones.
In particular condominium or industrial contexts, where single-phase users can be connected to different phases of the three-
phase distribution provided by the public operator, the DCONNECT BOX 2 and the pump might not be able to communicate.
After having correctly connected the hydraulic and electrical part, it is sufficient to supply power and the system is ready to work.
The pump can be controlled and set through the appropriate app, installed on a smartphone or tablet.
The app can be downloaded from https://internetofpumps.com/ or from the major stores.
To enable the app to interact with the pump, the DCONNECT BOX 2 must be correctly installed and powered. The LEDs on the DCONNECT
BOX 2 monitor the connection status with the pump and the app.
ENGLISH
Installation example
Accessories available
Description
Raised suction
Level float for stopping the pump
Measurement of the water left in the tank with level float function
Protection against galvanic corrosion
Surface pump conversion kit
Table 2
21
Advertisement
Table of Contents
