Speed Nut; Choke-Lever Assembly - Toro 132-9543 Installation Instructions Manual

Installing the Mow-Control Assembly
1. Use the 2 bolts (#10 x 1/2 inch) and locknuts to secure
the joystick assembly to the console
Figure 17
1. Knob
2. Dust boot
3. Bolt
2. Install the dust boot over the joystick shaft.
3. Install the knob to the joystick shaft.
(Figure 17).
4. Nut
5. Mow-control assembly
Installing the Choke Assembly
Gas Engine Only
1. Follow the original cable routing to route the new
choke cable and secure it to the machine with cable
ties (Figure 18).

1. Choke-lever assembly

2. Choke cable
2. Connect the cable to the choke control on the engine
(Figure 18).
3. Install the speed nuts onto the mount on the console
assembly (Figure
4. Use the 2 bolts (#10 x 1/2 inch) to secure the
choke-lever assembly to the console
1. Speed nut (installed)
2. Bolts (#10 x 1/2 inch)
8
Figure 18
3. Choke control
19).
(Figure
Figure 19
3. Choke-lever assembly
19).