Table of Contents
Advertisement
Figure 38
1. Reel motor
4. Move the motor to the storage location on the front
of the suspension arm (Figure 39).
Figure 39
Note: When sharpening, setting the height-of-cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in
the storage location on the front of the suspension
arms to prevent damage to them.
Important: Do not raise the suspension to the
transport position when the reel motors are in
the holders in the machine frame. Damage to
the motors or hoses could result. If you must
move the traction unit without the cutting units
installed, secure them to the suspension arms
using cable ties.
5. Open the latches on the suspension-arm bar of the
cutting unit you are removing (Figure 35).
2. Motor retaining bar
6. Disconnect the latches from the cutting-unit bar.
7. Roll the cutting unit out from under the suspension
arm.
8. Repeat steps 3 through 7 for the other cutting units
as required.
9. Connect the cutting unit power
disconnect couplers; refer to
Cutting Unit Power Disconnect Couplers (page 23).
Setting the Reel Speed
To achieve a consistent, high quality–of–cut and a
uniform after cut appearance, it is important that the
reel speed control (located on the manifold block under
the cover to the left of the seat) be correctly set.
Adjust the reel speed control as follows:
1. Select the height-of-cut at which the cutting units
are set.
2. Choose the desired ground speed best suited for
conditions.
3. Using the appropriate graph (See Figure 40) for 5, 8,
11, or 14 blade cutting units, determine the proper
reel speed setting.
4. To set the reel speed, rotate the knob (Figure 41)
until the indicator arrows are in line with the
number designating desired setting.
33
Figure 40
g014736
Advertisement
Table of Contents
