Figure 7
1. Retaining nut
2. Washer
6. Remove the knob from the function lever
Figure 8
1. Bolt
2. Nut
7. Remove the bolt and nut that secures the function-lever
assembly to the function-lever bracket
8. Remove and discard the 2 bolts and nuts that secure
the function-control bracket to the console assembly
(Figure
9).
3. Proximity sensor
(Figure
8).
3. Function-lever assembly
4. Knob
(Figure
8).
1. Bolt
2. Function-control assembly
Disconnecting the Choke Cable
1. Disconnect the cable from the choke control on the
engine.
2. Remove the cable from the traction unit.
3. Leave the cable connected to console assembly, it will
be removed with the console assembly.
Note: Replace but do not completely tighten the cable ties
when you remove the choke cable. This will also help you
when routing the new cable.
5
Figure 9
3. Nut