Furuno VR-3000 Operator's Manual page 29

Error
code
206 PRC_RECORDING_STOPPED_
INDICATION
214 PRC_STATUS
RUNNING_ON_BATTERY
218 PRC_STATUS_MIC_TEST_FAILED
226 PRC_NUM_FLASH_DRU_ERROR
234 PRC_UTC_TIMEOUT
238 PRC_SYSTEM_DRIVE_FAILURE
246 PRC_STATUS_PDU_NO_
CONNECTION
254 PRC_SELFTEST_FAILED
300- PRC_SERIAL_TIMEOUT (250)
315
Error codes (con't from previous page)
Name Description
The VR-3000 has
stopped recording. The
system has been running
on BATTERY only, for
more than two hours.
Both AC and DC power
are down. Audible alarms
will only be generated for
max. two minutes.
This ALARM is issued
when the microphone test
fails to test the
microphones defined in
the WEB_configurator.
This test can be run from
CONFIGURATION menu
in the WEB_configurator,
and is run every 12-hours
during normal operation
(first time 2-minuttes after
system-start).
This indicates that no. of
FLASH devices found in
DRU and defined in
CONFIGURATION is not
same.
System has not received
UTC info within two
minutes after system start
up
System did not find valid
system drive (DRU).
The cable between PDU
and CPU block is not
connected.
System failed SELFTEST. Connect via web
A serial channel has not
delivered data within the
specified timeout period.
Action
Reconnect AC or DC
power. The system will
start recording after 30
seconds.
Reconnect AC or DC
power.
Check if microphones
mounted are disabled
in the
WEB_configurator.
(AUDIO
section>channels (3, 4,
5)). If this is OK, locate
the faulty microphone
and check/replace it.
Check if
CONFIGURATION is
correct. If correct,
check if DRU is correct.
Check that a valid UTC
source is connected to
the serial port defined
as UTC source.
Check that valid DRU is
connected. (Validated
flashdrives installed.)
Reconnect cable
between PDU and CPU
block in DCU.
browser or VGA screen
to see reason for
failure.
Reconnect serial data.
Check failed device.
19