Removing Hdd; How To Release Dru - Furuno VR-3000 Operator's Manual

1.4 Removing HDD

VDR information is copied automatically into the backup hard disk drive (HDD) for more than 12
hours (max. 48 hours) and is then automatically written over with new data. Bring the HDD with
you after an incident if possible.
To remove the HDD, do the following:
1. Press the SAVE button (long press) on the RAP (Remote Alarm Panel). The yellow LED starts
blinking, showing that recording is being terminated.
2. Wait until the LED lights steadily.
3. Open the DCU with the key and turn off the power.
4. Pull the knob on the HDD door to open the door.
5. Disconnect the IEEE1394 cable.
6. Remove the HDD.

1.5 How to Release DRU

To remove the DRU from the bracket (cradle)
do the following:
1. Loosen the hand-tightened cap.
2. Pull the DRU cable straight out.
(The cable may be cut after an incident.)
3. Remove two snap pins and then two hinge
pins.
4. Lift the release levers.
8
HD
DCU, showing location of HDD
3. Hinge pin
Knob
HDD
IEEE1394
Cable
4. Release levers.
1. Cap
2. DRU cable
3. Snap pin