Furuno VR-3000 Operator's Manual page 27

Error
code
042 PRC_STATUS_GRABBER_FAILURE_
INDICATION
046 PRC_STATUS_DRU_INDEX_ERROR
062 PRC_STATUS_STORAGE_LAST_
BUFFER_NOT_SAVED
066 PRC_STATUS_CONFIGURATION
INITIALIZATION FAILED
082 PRC_STATUS_RAP_MISSING
084 PRC_STATUS_AP_MISSING
086 PRC_STATUS_CONFIG_
VDRDEFAULT_ERROR
088 PRC_RJB_MISSING
094 PRC_RECORDING_BACKUP_
INACTIVE
098 PRC_RECORDING_DRU_INACTIVE
102 PRC_STATUS_CONFIG_UNABLE_
TO_SAVE
106 PRC_STATUS_SYSTEM_STOPPED
(Continued on next page)
Error codes (con't from previous page)
Name Description
One of the active/enabled
video channels can't grab
from the channel. This
can be either because
radar is turned OFF or
wrong configuration.
This indicates problem
with INDEX in DRU.
Storage problem with
DRU/BACKUP.
This indicates that
CONFIG was unable to
initialize
CONFIGURATION.
RAP is missing.
Connection to RAP is lost.
No alarm panel
connection
Built-in configuration in
VR-3000/S system
software failed to load into
DRU. Reason can be
firmware itself or problem
with DRU.
Indicates the Junction
Box is missing.
Indicates that Backup is
inactive – not storing data.
Indicates that DRU is
inactive – not storing data.
VR-3000/S could not save
configuration to
DRU/BACKUP-DRIVE.
SYSTEM_STOP request
has been completed
(system has stopped
collecting data).
Action
If radar is turned OFF,
press ACK on the RAP
to silence alarm. Error
will clear when radar is
turned ON again. If
radar is ON, check
installation (cabling)
and configuration.
Check LOG and clear
INDEX.
Check LOG or contact
dealer for repair.
Check LOG and/or
contact supplier for
repair.
Check cabling to RAP.
Reconnect RAP.
Check connection to
alarm panel.
Clear CONFIG_area
and restart VR-3000/S.
This will install a
"default minimum"
configuration. If the
error still occurs, try to
see if DRU is set up
correctly (partitions,
partition size).
Check cabling and
IP-ADDR setting on
DIP SW S5 in JB.
Check communication
to Backup HDD.
Check communication
to DRU.
Check DRU connected;
BACKUP DRIVE OK;
For other call for
service.
Turn off all power
switches to power
down, or recycle power
to restart.
17