Basic Operation Procedure (External Operation); Setting The Frequency On The Operation Panel - Mitsubishi Electric FR-A800 Series Instruction Manual

4.6
Select a method to give the frequency command from the list below, and refer to the specified page for its procedure.
Setting the frequency on the operation panel in the frequency setting mode
Turning ON/OFF switches wired to inverter's terminals (multi-speed setting)
Setting the frequency by inputting voltage signals
Setting the frequency by inputting current signals
4.6.1
• Turn ON the STF/STR signal to give a start command.
• Use
• Set Pr.79 = "3" (External/PU combined operation mode 1).
[Connection diagram]
Forward rotation
start
Reverse rotation
start
Switch
The following shows the procedure to operate at 30 Hz.
Operating procedure
1.
Changing the operation mode
Set "3" in Pr.79. [PU] and [EXT] indicators are ON. (To change the setting, refer to
2.
Setting the frequency
Turn
While the indication is flashing, press
displayed alternately. After about three seconds of alternate display, the monitor display goes back to "
indication of a monitored value). (If
display goes back to "
3.
Start → acceleration → constant speed
Turn ON the start switch (STF/STR signal). The frequency value on the monitor increases according to the setting
of Pr.7 Acceleration time, and "
forward rotation, and [REV] indicator is ON during the reverse rotation. (To change the set frequency, return to step
2. The previously set frequency appears.)
4.
Deceleration → stop
Turn OFF the start switch (STF/STR signal). The frequency value on the monitor decreases according to the setting
of Pr.8 Deceleration time, the monitor displays "
Downloaded from ManualsNet.com

Basic operation procedure (External operation)

Method to give the frequency command

Setting the frequency on the operation panel

on the operation panel (FR-DU08) to give a frequency command.
Inverter
STF
STR
SD
until the target frequency "
" (0.00 Hz). In that case, turn
search engine
Operation panel
(FR-DU08)
" (30.00 Hz) appears. The indication blinks for about five seconds.
to confirm the selection for the frequency. " " and "
is not pressed during the flashing for about five seconds, the monitor
again and set the frequency.)
" (30.00 Hz) appears on the monitor. [FWD] indicator is ON during the
" (0.00 Hz), and the motor stops rotating.
4.6 Basic operation procedure (External operation)
Refer to page
155
156
157
160
page 142.)
"are
" (the
4. BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
155