Wireless Remote Controller Unit Operation Distance - Mitsubishi Electric RCN-K-E Installation Manual

6 Wiring
Control plural indoor units with one remote controller
Up to 16 indoor units can be connected.
1 Connect indoor units with each other with 2-core wires. As
for size, refer to the following note.
2 The receiver wires must be connected only with the indoor
unit that will be operated by the remote controller directly.
3 Use the rotary SW1 and SW2 provided on the indoor unit
PCB (Printed circuit board) to set unique remote control
communication address avoiding duplication.
Restrictions on the thickness and length of wire
(Maximum total extension 600m.)
Standard Within 100m x 0.3mm
Within 200m x 0.5mm
Within 300m x 0.75mm
Within 400m x 1.25mm
Within 600m x 2.0mm
7 Wireless remote controller operation distance
1
Standard signal receiving range
[Condition]
Illuminance at the receiver area: 360 lux.
(When no lighting fixture is located within 1m of indoor unit in an ordinary office)
2
Points for attention in connecting a plural number of indoor units
[Condition]
Illuminance at the receiver area: 360 lux.
2
2
2
2
2
Wireless remote
controller unit
Floor surface
Within 5m
Receivable range
60
-
Outdoor unit
Indoor unit
Outdoor No.01
Indoor No.01
Indoor unit
Outdoor No.01
Indoor No.02
Indoor unit
Outdoor No.01
Indoor No.03
Receivable range
5m
(Top view)
Receivable range
60
7
-
Outdoor unit
No.01 No.02
Indoor unit
Outdoor No.02
Indoor No.04
Indoor unit
Outdoor No.02
Indoor No.05
Indoor unit
Outdoor No.02
Indoor No.06
Interface PCB
Remote controller line
8
(No polarity)
Receiver
(Top view)
60
6