The System - Intec FORCE 3 Instruction Manual

FORCE / 3

The System

Three sub-systems make up your FORCE/3:
THE AGITATOR AND AIRLOCK.
motor and is coupled to a worm gearbox to reduce the speed of the
motor and increase torque. In addition to the motor and gearbox, chain
and sprockets are used to further reduce the speed of the airlock.
THE BLOWER MOTOR(S).
5.7" 128 CFM three stage blowers to push the material through the hose
and into the attic with optimum pressure and output. The Force/3 4.0 DP
is equipped with two 116 CFM two stage blowers which produce over 4.0
PSI through the airlock.
ELECTRICAL SYSTEM.
dedicated 20 amp grounded circuits.
Low voltage or amperage may likely
cause tripping (blowing) of house
circuit breakers or chattering of
contactor (relay). The Force/3 4.0 DP
requires 2 dedicated circuits, 20 & 30
amp. Due to the high current draw of
this machine you will need to use a
10.5KW generator to properly operate it. Never attempt to operate the
FORCE/3 in standing water!
Always disconnect all power to the equipment before attempting
repair; otherwise bodily injury or death may result.
THE PARTS.
1. Hopper: upper component of the FORCE/3 where insulation is
loaded.
2. Frame: Lower part of the machine that supports the entire
machine.
3. Side panels: surround the outside of the machine to aid in
protection during operation.
4. Electrical: on/off function for both the blower and agitator motors.
3.0 & 4.0 DP
The FORCE/3 3.0 is equipped with two
The FORCE/3 3.0 requires 2 separate
7
The FORCE/3 uses a 1- 1 ⁄ hp
2