Advertisement
BE CAREFUL REMOVE THE PART AS SHOWED BELOW
EXTRACTION OF THE INSERT , COLD, WITHOUT
OPTIONAL
CAUTION:
BEFORE PROCEEDING, MAKE SURE THAT THE
INSERT IS FIXED TO THE BASE.
To extract the insert, proceed as follows:
• Open the door and lift the slide lock (F).
• Attach the handle provided to the two pins fixed to the
lower grille (G) and pull the insert towards you as
far as it will go
Each time the insert is removed, a security
system cuts off the power supply. Should the
insert be removed involuntarily during ignition,
operation or while switching off (including
while blocked), the "Power failure" block
phase will be launched when the insert is
reinserted.
Wait for the block phase to end before
reactivating the insert.
IT IS IMPORTANT FOR
SAFETY REASONS THAT
THE PRODUCT IS FIXED
AT THE FLOOR
USER INSTRUCTIONS
INSTALLER
F
G
Rack and frame are optional
23
Advertisement
