Advertisement
Quick Links
• Visit http://www.corning.com/cablesystems for the in-depth installation manual. Search for part
number 003-876.
1.
Carton Contents
Sliding cover
1
Label card
2
Mounting bracket
3
Door latch
4
5
Blank adapter panel
1
2
2.
Mounting the housing
Install two #12-24 x 0.5
2a
Phillips-head screws
at desired height.
Leave gap behind head.
2a
STANDARD RECOMMENDED PROCEDURE 003-876-QSG | ISSUE 2 | OctOber 2011 | PAGE 1 OF 6
6
Sliding tray
7
Slack management clip
8
Internal strain-relief assembly
9
Transitional strain-relief holder
10
External strain-relief assembly
3
11
4
Slide mounting bracket notch
2b
over screw heads.
2b
closet connector Housing
(ccH) 1U/2U/3U Quick
Start Guide
p/n 003-876-QSG, Issue 2
11
Jumper guide
8
7
6
5
5
4
2c
9
10
3
11
TPA-3873
Install next two screws in
center notch of mounting
bracket; tighten all screws.
2c
TPA-3874
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for CORNING CCH 1U
Summary of Contents for CORNING CCH 1U
- Page 1 Housing (ccH) 1U/2U/3U Quick Start Guide p/n 003-876-QSG, Issue 2 • Visit http://www.corning.com/cablesystems for the in-depth installation manual. Search for part number 003-876. Carton Contents Sliding cover Sliding tray Jumper guide Label card Slack management clip Mounting bracket...
- Page 2 aCCessing the housing Open front and rear doors. Lift plunger on internal strain-relief assembly. Pull covers with moderate force Push bracket to rear to disengage and remove in opposite directions to remove. it from the housing. Plunger Slide tray toward rear of housing. Set tray and strain-relief assembly on work Press latches on both sides to release tray surface for next operations.
- Page 3 4.2. sheath retention Small diameter cable: Cable tie to 2 bridges Large diameter cable: Cable tie to all 4 bridges Bundle of small diameter cable: Cable tie bundle together, then cable tie to all 4 bridges TPA-3877 4.3. Strain-relieving to the Transitional Strain-Relief Holder Replace blank panels with adapter OR Secure loose tube Press buffer tube...
-
Page 4: Cable Routing
4.4. Cable Routing Route 900 micron fibers as shown on etching on shelf. 4.4a NOTE: Reverse fiber routing if cable enters from other side of the housing. 4.4b Secure fibers in slack management clips. 4.4c Clean and mate adapters and connectors. TPA-3879 To reinstall internal strain-relief 4.4d... -
Page 5: Completing Installation
Corning Cable Systems reserves the right to improve, enhance, and modify the features and specifications of Corning Cable Systems’ products without prior notification. LANscape is a registered trademark of corning cable Systems brands, Inc.. All other trademarks are the properties of their respective owners. corning cable Systems is ISO 9001 certified. - Page 6 TPA-3882 STANDARD RECOMMENDED PROCEDURE 003-876-QSG | ISSUE 2 | OctOber 2011 | PAGE 6 OF 6...
Need help?
Do you have a question about the CCH 1U and is the answer not in the manual?
Questions and answers