Sump Module - Haier GE CDT800P2N3S1 Technical Service Manual

https://appliancetechmanuals.com

Sump Module

The ultra-fine filter is a twist lock design and
consumer cleanable. To remove, turn counter-
clockwise (CCW).
The fine filter is secured by the ultra-fine filter and
two tabs. To remove, remove the ultra-fine filter
and lift up on the front, allowing the back to slide
out of the tabs.
Also located on the top side of the sump are the
diverter components. The bottom of the diverter
is molded into the sump. A check ball or two port
diverter and a pressure diverter are used in these
models. The pressure diverter may use 3 or 4
ports controlling reversing spray arm on some
models and silverware wash on some models.
Full details on both diverters are found in the
Circulation section of this service guide.
Two Port Diverter
Four Port Pressure Diverter
Components on the bottom of the sump include
a pressure switch, turbidity sensor, drain pump,
circulation pump and some models have a
diverter location switch.
The sump module is front serviceable with the
dishwasher remaining in the installed location
by removing the door for easier access. This
section of the guide only covers the sump
removal. Components and diagnostics of the
sump module may be found in the Fill System,
Circulation System or Drain System sections of
this service guide.
The shaded portions indicated molded sump.
– 38 –