Table of Contents
Advertisement
3. Installation and Configuration
Configuration is required only if ISY does not show up automatically.
3.1
Installation
Please perform the following steps before plugging the ISY into power:
i.
Connect the Ethernet cable to ISY and to your network hub. Note: the
network must be DHCP enabled. If your DHCP is not enabled, please
consult ISY Installation and Configuration Guide on the accompanying
CD
ii.
Connect the Serial communications cable, provided with your Insteon
PLM (sold separately), to the connector marked Port A on the ISY and to
your computer.
Plug in the power supply into ISY and then into a power outlet.
3.2
Prerequisites
3.2.1 Host Computer Software
i.
Windows XP (for other versions of Windows, a separate guide is
provided)
ii.
Internet Explorer 6 and above
iii.
Java 1.5 (JRE 1.5) – included in the setup disk
iv.
Microsoft Excel, for trending and charts
3.2.2 Network
ii.
DHCP enabled network
iii.
Ethernet topology
3.3
Host Computer Configuration
Configuration is comprised of three very easy steps:
i.
UPnP Configuration
ii.
Java Installation
- 6 -
Advertisement
Table of Contents
