Table of Contents
Advertisement
For facilities where all of the power is in the same solar park, the power must be distributed between the two tracks, joining both
inverter inputs as shown in the diagram below:
This configuration requires modification of the "Adjust Model" parameter on the device. Refer to the section titled "Changing
the MPPT Model" (Page 17).
Strings that can be connected to each MPPT, depending on the device model:
Model
EQX 5000-2T
EQX 8000-2T
EQX 10000-2T
3.2. AC (ALTERNATING CURRENT) INSTALLATION
Make sure the protection systems in the junction box are activated and that there is no voltage in the cables you are going to
handle.
If you are installing the optional ESM3T EQX energy meter, we recommend installing the inverter as near to the electrical connection
as possible, in order to avoid extending the RS485 communications cable.
Material required:
10
String / MPPT
1/2
1/2
1/2
SALICRU
Advertisement
Table of Contents
