Attaching The Embroidery Frame - Brother 888-K80 Operation Manual

b Place the embroidery sheet on the inner frame.
c Line the mark on the fabric up with the base line on the
embroidery sheet.
d Place the inner frame with the fabric on the outer
frame and adjust the fabric if needed to align marks on
fabric with the embroidery sheet.
• For details, refer to page 28.
e Remove the embroidery sheet.

Attaching the embroidery frame

Note
• Wind and insert the bobbin before attaching the
embroidery frame making sure to use the
recommended bobbin thread. Check that there is
enough thread in the bobbin.
a Raise the presser foot lever to raise the presser foot.
b While lightly holding the lever on the frame holder to
the left, align the two pins on the embroidery frame
holder with the mounting brackets on the frame, and
then press the frame into the embroidery frame holder
until a click is heard.
Hold the lever lightly to the left.
a
1 Lever
Embroidering Preparation
Press the front mounting bracket onto the pin until it fits
into place.
a
1 Front mounting bracket
2 Front pin
Press the back mounting bracket onto the pin.
a
b
1 Back mounting bracket
2 Back pin
b
2
29