Winding/Installing The Bobbin; Winding The Bobbin - Brother 888-K80 Operation Manual

■ Setting the wireless LAN connection from the
[Others] menu
The [Others] menu on page 8 of the settings screen
contains the following items.
1
2
3
4
1 TCP/IP settings can be manually entered.
2 Shows the MAC address.
3 Use when proxy settings are required.
4 Resets the wireless LAN connection settings.

Winding/Installing the Bobbin

Winding/Installing the Bobbin
IMPORTANT
• Use the plastic bobbin that comes with this
machine or bobbins of the same type. The
bobbin's height is 11.5 mm (approx. 7/16
inch). SA156 is a Class 15 type bobbin.

Winding the bobbin

This section describes how to wind thread onto a bobbin.
Note
• When winding bobbin for embroidery, be sure to
use the recommended bobbin thread for this
machine.
a Open the top cover.
b Place the bobbin on the bobbin winder shaft so that the
notch in the bobbin aligns with the spring on the shaft,
and then slide the bobbin winder shaft to the right until
it snaps into place.
a
b
Memo
• By placing the bobbin into the bobbin case in the
same orientation that it was on the bobbin winder
shaft, the bobbin can be installed with the correct
winding direction of the bobbin thread.
The "b" mark on one side of the bobbin included
with this machine can be used as a reference.
1
1 Notch
2 Bobbin winder
shaft spring
17