Table of Contents
Advertisement
n
Lower the needle threader lever on the left side of the
machine until it clicks, and then slowly return the lever
to its original position.
1 Needle threader lever
2 Needle
3 Hook
o
Carefully pull the end of thread that was passed
through the eye of the needle.
If the needle was not completely threaded, but a loop in
the thread was formed in the eye of the needle, carefully
pull the loop through the eye of the needle to pull out
the end of the thread.
p
Raise the presser foot lever, pass the end of the thread
through and under the presser foot, and then pull out
about 10 cm (approx. 4 inches) of thread toward the
rear of the machine.
q
Touch
to unlock all keys and buttons.
1
2
■ Thread and needle number
3
■ Embroidery needles
Before using the needle, place the flat side of the needle on a
flat surface and check that the distance between the needle
and the flat surface is even.
Replacing the Needle
CAUTION
• Only use recommended home sewing machine
needles. Use of any other needle may break
the needle, possibly resulting in injury.
• Never use bent needles. Bent needles can
easily break, possibly resulting in injuries.
The lower the thread number is, the heavier the thread;
the higher the needle number, the larger the needle.
It is recommended to use a 75/11 home sewing machine
needle. However, if the machine is not stitching well
when embroidering on heavy weight fabric, please try a
90/14 needle.
Checking the needle
1
2
d
c
e
Note
• The machine needles are consumables. Replace
the needle in cases such as those described
below.
- If an unusual sound is produced when the needle
enters the fabric. (The tip of the needle may be
broken or dull.)
- If stitches are skipped. (The needle may be bent.)
Replacing the Needle
1 Flat side
2 Needle type marking
3 Flat surface
4 Even
5 Not even
23
1
Advertisement
Table of Contents
