Attaching The Embroidery Frame - Brother NQ3700D Operation Manual

Embroidering Preparation
b Place the embroidery sheet on the inner frame.
c Line the mark on the fabric up with the base line on the
embroidery sheet.
d Place the inner frame with the fabric on the outer
frame and adjust the fabric if needed to align marks on
fabric with the embroidery sheet.
Remove the embroidery sheet.
e

Attaching the embroidery frame

Note
• Wind and insert the bobbin before attaching the
embroidery frame making sure to use the
recommended bobbin thread. Check that there is
enough thread in the bobbin.
a Press (Presser foot lifter button) to raise the presser
foot.
b Raise the frame-securing lever.
1 Frame-securing lever
2 Carriage
84
c Align the embroidery frame guide with the right edge
of the embroidery frame holder.
1 Embroidery frame holder
2 Embroidery frame guide
d Slide the embroidery frame into the holder, making
sure to align the embroidery frame's arrow mark with
the one on holder.
1 Arrow mark
e Lower the frame-securing lever to be level with the
frame to secure the embroidery frame in the
embroidery frame holder.
CAUTION
• If the frame-securing lever is not lowered, the
following message appears. You cannot start
embroidering until you lower the frame-
securing lever.