Table of Contents
Advertisement
Winding/Installing the Bobbin
c
Touch
.
The screen changes, and all keys and operation
buttons are locked (except
d
Raise the presser foot lever.
e
Slide the bobbin cover latch to the right and remove
the bobbin cover.
f
Insert the bobbin into the bobbin case so that the
thread unwinds to the left.
Memo
• For the correct winding direction of the bobbin
thread, be sure to place the bobbin into the bobbin
case in the same orientation that it was on the
bobbin winder shaft.
The "b" mark on one side of the bobbin included
with this machine can be used as a reference.
20
g
).
h
i
j
k
Lightly hold down the bobbin with your right hand
(1), and then guide the end of the thread around the
tab of the needle plate cover with your left hand (2).
1 Tab
Note
• Be sure to hold down the bobbin with your finger
and unwind the bobbin thread correctly, otherwise
the thread may break or the thread tension will be
incorrect.
While lightly holding down the bobbin with your right
hand (1), guide the thread through the slit in the
needle plate cover (2) and lightly pull it with your left
hand (3).
Memo
• By pulling the thread in this way, the thread will
enter the tension spring of the bobbin case to apply
the appropriate tension to the bobbin thread during
embroidering.
While lightly holding down the bobbin with your right
hand (1), continue guiding the thread through the slit
with your left hand (2). Then, cut the thread with the
cutter (3).
Reattach the bobbin cover.
Insert the tab of the bobbin cover into the notch of the
needle plate cover, and then lightly press down on the
right side.
Touch
to unlock all keys and buttons.
Advertisement
Table of Contents
