Maintenance - Schaudt DT 220 B Instruction Manual

DT 220 B control and switch panel instruction manual
Cleaning
Tank sensors/
tank probes
26
5.8.2 Closing down for more than 6 months
The leisure battery must be fully charged before closing the system
down.
Disconnecting the leisure battery from the 12 V power supply (see Chap-
ter 5.8.1).
Remove the clamps from the battery terminals.
More detailed information can be found in the EBL ... Electrobloc instruc-
tion manual.
6

Maintenance

The control and switch panel requires no maintenance.
Clean the front plate using a soft, moist cloth and mild detergent. Never use
spirit, thinners or similar substances. Do not allow fluid to ingress the control
and switch panel.
Clean the sensors/probes (the sensor/probe surfaces must always be
clean). Inform Schaudt GmbH customer service department if a problem still
exists.
The reproduction, translation and duplication of this manual, even in parts, is
E
not allowed without written authorisation.
Issued: 30.06.2006 830.588 BA / EN