Schaudt DT 220 B Instruction Manual page 13

5.4.2.3
830.588 BA / EN
DT 220 B control and switch panel instruction manual
Standard factory setting: 130 Ah
Y
The nominal battery capacity (e. g. in the event of retrofitting a battery)
can be set up in the 90 Ah to 495 Ah range.
Entering the K100 setting (multiply the K20 setting by 1.125 and use the
result if this has not been entered previously).
Use the "+" or "--" buttons to adjust the setting.
Confirm the entry by pressing "OK".
The installed (nominal) leisure battery capacity will be displayed conti-
F
nuously.
If the installed battery capacity changes or if the "OK" button in the cor-
Y
responding programming menu is pressed, the control and switch panel
of the remaining battery capacity is initially set at 50% and is followed by
a question mark until the battery is fully charged again (e.g. 75 Ah?).
If the installed battery capacity should only be displayed but not adjusted,
you must not press the "OK" button. To leave the menu press one of
the menu buttons (the menu is automatically switched off after 20 se-
conds).
Press the "OK" button if the display is lit up.
Press the "Battery menu" button when you have completed all of the
entries.
The display will remain illuminated.
F
The remaining utilisable leisure battery capacity will now be displayed.
F
The system uses the current leisure battery charge status to calculate
this setting.
Switching the water pump on and off
This function is only available if the relevant "Water tap" function is
Y
already activated. Only the vehicle manufacturer can activate it at a later
date.
Press the "Tank menu" button.
The display will illuminate.
F
The water tank filling level is now displayed.
F
Press the "OK" button if the display is lit up.
The "water pump" symbol is displayed /disappears
F
The power supply for the water pump is switched on/off.
F
When the control and switch panel DT 220 B is in this mode, the "OK"
Y
button is used to switch the current setting.
Issued: 30.06.2006
13