Schaudt DT 220 B Instruction Manual page 11

5.4.1
5.4.2
5.4.2.1
830.588 BA / EN
DT 220 B control and switch panel instruction manual
Switching on the 12 V supply to the living area
The control and switch panel should only be switched on if the leisure
Y
battery voltage lies above 11.0 V; otherwise the voltage display (e.g.
"10.2 V") will flash every time you try to switch on. See Chapter 5.6 as
well.
Press the "12 V" button briefly.
The display will illuminate.
F
The time will now be displayed on the main display.
F
Any alarm that is set (e.g. "CHARGE") will be indicated (see Chapter
F
5.6).
The 12 V power supply in the living area is now switched on.
F
Section 5.7 describes how to switch off the 12 V power supply for living
Y
areas. (operating units: see section 5.1)
Setting up
The settings are entered via the setting up modes in the various menus.
Y
Setting up mode is called up using the "Set up" button.
You can exit setting up mode from any point just by pressing one of the
"Main menu", "Battery menu" or "Tank menu" buttons. Pressing the "12
V" main switch will also exit setting up mode. Any entries that have not
been saved (press the "OK" button to save them) will be lost.
Date and time
Press the "Main menu" button.
The display will illuminate.
F
The time and other symbols (if required) will be displayed.
F
Press the "Set up" menu button and keep it held down for at least 3 s.
The display will change over to main menu set up mode.
F
Keep pressing the "Set up" button until the hour display starts to flash.
Use the "+" or "--" buttons to set the hours.
Confirm the entry by pressing "OK".
The minute display flashes.
F
Use the same procedure to set the minutes.
Press the "Set up" menu button.
The year display flashes.
F
Issued: 30.06.2006
11