Related Manuals for Ingersoll-Rand Quantum QCH Series
Summary of Contents for Ingersoll-Rand Quantum QCH Series
- Page 1 04585147 Edition 2 November 2006 Quantum Electric Chain Hoist QCH Series 1/8 to 5 ton Product Information Save these Instructions...
-
Page 2: Product Safety Information
PRODUCT SAFETY INFORMATION Refer to Product Safety Information Manual for Quantum Intended Use Electric Chain Hoists Form 16586075. Quantum Series Electric Chain Hoists are designed to Manuals can be downloaded from www.irtools.com efficiently raise and lower loads. These hoists are designed for general industrial material handling operations, with freely suspended loads. -
Page 3: Control Switch
The standard equipment of the electric chain hoist includes a Control Switch control switch (raise/lower with emergency stop). The automatically disconnecting emergency stop contact of the control switch directly opens the power circuit which powers the contactors. A 4-button or 6-button control switch is attached to the motorized trolley as required for additional movement directions. -
Page 4: Operational Parameters
OPERATIONAL PARAMETERS Quantum Electric Hoists are intended for general industrial The operational parameters do not include: material handling operation with freely suspended loads. - exceeding the defined load capacity, - diagonal pulling of the load or yarding, The electric chain hoists of the QCH Series are capable of - excessive impact or lifting of guided loads. -
Page 5: Power Connection
spacers must be equally distributed on the outside of the and switch enclosures are adequately sealed and protected side plates. for the environmental conditions to be encountered. WARNING The electric chain hoist must be connected in accordance with supplied wiring diagrams. Remove approximately 3/8 in. •... -
Page 6: Load Chain
Double fall operation: Connect load side of chain end to Load Chain chain retainer and fix in housing guide rail (3). Bottom sheave (1) with load hook (2). Apply grease in the hook CAUTION block recess (see figure 6). • Only use original chains. •... -
Page 7: Limit Switch
4. Activate rocker, move to lowest hook position, rotate Limit Switch green switching wheel (rear) (4) to switching cam of bottom limit switch (5); (rotate anticlockwise for higher The electric chain hoist is equipped with a geared limit hook position and clockwise for lower hook position). switch as standard. - Page 8 LUBRICATION To ensure continued satisfactory operation of the hoist, all Gears points requiring lubrication must be serviced with the correct lubricant at the proper time interval as indicated for each The gear compartment is filled with grease at the factory to assembly.
-
Page 9: Parts And Maintenance
PARTS AND MAINTENANCE Hoists repairs should be made by designated trained personnel. Consult your nearest Ingersoll Rand Certified Service Center or lifting care specialists for additional information. The use of other than genuine Ingersoll Rand parts may result in a hazard, decreased performance and increased maintenance and may void all warranties. - Page 10 NOTES 04585147_ed2...
- Page 11 NOTES 04585147_ed2...
- Page 12 www.irtools.com © 2006 Ingersoll Rand Company...