E Operating Procedure; Switching Off In An Emergency; Switching On After Emergency Stop - Kärcher CWP 2000 Operating Instructions Manual

CWP 2000

E Operating procedure

Fig. E.3: Control cabinet
5.959-373 A 2006471 (06/03)
Operating Instructions
E.1 Switching off in an emergency
If persons, property and animals are in danger, the
system must be switched off immediately by pressing the
"EMERGENCY STOP" button. You will find
"EMERGENCY STOP" buttons
n on the control unit (option)
n on the wash-card reader (option)
n on the control panel for manual operation
n or installed by the operator.
In self-service systems, a competent person who is
familiar with the system must be reachable who is able to
carry out or initiate the measures necessary to avoid any
potential danger.
E.2 Switching on after Emergency STOP
Before switching on again, the cause of the Emergency
STOP button being activated must be remedied. Vehicles
must be driven out of the system.
n Release the arrest of the Emergency-stop button.
n Press the button "start position" on the control panel
In the start position, the top green signal light "Forwards"
of the positioning light (optional) lights up. The system is
again operational and the vehicle to be washed can be
driven in.
n Start the wash programme again.
E.3 Initial operation of the system by the operator
n Open the shut-off valves in the water and compressed
n Switch the master switch (17.1) on the control cabinet
n Press the button "Start position" on the control panel
The system is ready to operate, the vehicle to be washed
can be driven in.
17.1
i
Important!
i
Important!
for manual operation.
air lines
to "ON"
for manual operation.
English
E1