Battery Charging; Control Panel - LaserLiner DuraMax Manual

Battery charging

– Charge the device's battery completely prior to use
– Open the battery compartment (H), insert the batteries and connect the
plugs to the sockets. The plugs fit in the sockets in one position only (see
pictures on right). Reclose the battery compartment.
– Connect the battery charger/mains unit to a mains source and plug into the
socket (E). Please only use the charger/mains unit supplied with the device.
If a different one is used, the warranty will become void.
– The device can also be operated with standard alkali batteries (4 x type D).
Insert the batteries as shown by the installation symbols. Ensure the polarity
is correct.
– If the LED (I) blinks constantly, either the batteries must be exchanged or
recharged.
Inserting batteries into the Commander 50
– To insert the battery, open the cover fully
(see figure). Correct polarity must be
observed. Close the cover again fully.
C
D
E
F

Control panel

DuraMax
O
N
M
L
K
J I
14 GB
G H
Control panel
DuraMax XPro
O
P N
M
Q
L
K
I J
+
–
A Prism head
B Control panel
C Quick sighting
A
D Receiver diodes for
remote control (4 x)
E Charging socket
F Battery charge display
B
G 5/8" thread (bottom)
H Battery compartment
I Operating / Battery display
J Single slope function LED /
manual slope function LED
K Single slope function /
manual slope function
L X axis LED
M ON/OFF button
N Anti-shake function
O Anti-shake function LED /
P
Tilt function LED
Q
P Tilt function
Q Y axis LED
R
R Shutter function
(DuraMax XPro)