Inserting The Battery - LaserLiner SensoLite 310 Manual

Inserting the battery

Open the battery compartment on the
housing's rear side and insert a 9V battery.
Correct polarity must be observed.
In order to preserve the battery life,
the receiver switches off automatically
if it is not used for around 5 minutes.
Working with the laser receiver
Set the rotary laser to maximum speed and switch the laser receiver on.
It is able to detect the laser beam at a great distance now. Move the
SensoLite up and down through the laser beam until the middle indicator
(15) appears. Mark the measured height at the perimeter marking groove.
rapid peeping
The laser receiver has two tolerance settings:
– Free-hand range (12): Display with larger tolerance for rough
!
alignment by hand.
– Precision range (13): Display with smaller tolerance for precision
alignment (e.g. levelling staff).
10
EN
Laser
continuous tone
= mark the reference
–
+
9V
slow peeping