Sullair 600H User Manual page 85

SECTION 5
Figure 5-9: Air Filter Assembly
1. Housing
2. Secondary Element
3. Dust Collector
4. Primary Element
A F M
IR ILTER AINTENANCE
Refer to Figure 5-9. Air filter maintenance should be
performed when indicated on instrument panel
compressor air filter warning lamp. The air filters are
both equipped with a primary element and secondary
element each.
The secondary element must be replaced after every
third primary element change. DO NOT reconnect
the secondary element once it is removed.
600H, 700HH, 750, 750H, 750HH, 825, 900H, 1050 USER MANUAL
E R
LEMENT EMOVAL
1. Clean the exterior of the air filter housing.
2. Remove the service cover by unlatching the
four hook latches.
3. Remove the primary filter from the housing.
4. Clean the interior of the housing by using a
damp cloth. DO NOT blow out dirt with com-
pressed air as this may introduce dust down-
stream of the filter.
5. When it becomes necessary to remove the
secondary element, pull the element out of
the housing.
6. Install the new secondary element over the
rod.
7. With the secondary element in place, replace
the primary element.
* Primary Filter Element, Part No. 02250175-062
** Secondary Filter Element, Part No. 02250175-063
E I
LEMENT NSPECTION
1. Place a bright light inside the element to
inspect for damage or leak holes. Concen-
trated light will shine through the element
and disclose any holes.
2. Inspect all gaskets and gasket contact sur-
faces of the housing. Should faulty gaskets
be evident, correct the condition immedi-
ately.
3. If the clean element is to be stored for later
use, it must be stored in a clean container.
4. After the element has been installed, inspect
and tighten all air inlet connections prior to
resuming operation.
P E R
RIMARY LEMENT
1. Place the element in position over the sec-
ondary element.
2. Install the cover with clean-out port pointing
down. Clamp in place using all latches
located on canister.
EPLACEMENT
85