Raster Y Offset Command - HP PCL 5 Reference Manual

Once in Raster Graphics Mode, PCL commands and text imply an
End Raster Graphics (
In addition, the following commands are ignored (i.e., locked out)
while in Raster Graphics Mode and do not imply an End Raster
Graphics command:
Notes
An implied End Raster Graphics resets the Raster Compression
Method 3 seed row, but does not reset the Raster Compression
Method nor the left raster graphics margin.
If source and/or transparency modes have been set, frequent
start/end graphics commands in an image can result in a memory
overflow condition.

Raster Y Offset Command

The Raster Y Offset command moves the cursor position vertically
the specified number of raster lines from the current raster position in
the raster area.
Default
Range
This command is recognized only while in raster graphics mode and
only within the raster area.
EN
E
Transfer Raster Data
Set Raster Compression Method
Raster Y Offset
Start Raster Graphics
Set Raster Width
Set Raster Height
Set Raster Presentation Mode
Set Raster Graphics Resolution
E
* b # Y
C
# =Number of raster lines of vertical movement
= N/A
= 0 - 32767
) except for the following commands:
*rC
C
Raster Y Offset Command 15-15