Source Transparency Mode Command - HP PCL 5 Reference Manual

Table 13-1

Source Transparency Mode Command

The Select Source Transparency Mode command sets the source
image's transparency mode to transparent or opaque.
Default
Range
With a transparency mode of "0" (transparent), the white regions
of the source image are not be copied onto the destination. With a
transparency mode of "1" (opaque), the white pixels in the source
are applied directly onto the destination.
Refer to the preceding definitions and the discussion of Figure 13-3
for an explanation of the effects of transparency.
13-6 The PCL Print Model
(continued)
•
•
End of Page Data
E
* v # N
C
# =0 - Transparent
1 - Opaque
= 0
= 0, 1 (other values cause the command to be ignored)
EN