Vertical Rectangle Size (Decipoints) Command; Vertical Rectangle Size (Pcl Units) Command - HP PCL 5 Reference Manual

Vertical Rectangle Size (Decipoints) Command

This Vertical Rectangle Size command specifies the rectangle height
in decipoints.
Default
Range
The printer converts the specified width to printer dots by rounding
up to an integral number of dots. For example, 5 decipoints, which
corresponds to 2.08 dots in 300 dpi mode, is converted to 3 dots.

Vertical Rectangle Size (PCL Units) Command

This Vertical Rectangle Size command specifies the rectangle height
in PCL Units.
Default
Range
For example, if the unit of measure is set to 300 units-per-inch, to
specify a two-inch high rectangle, send the command:
The same command specifies a one-inch high rectangle if the unit
of measure is set to 600 units-per-inch.
Note The number of units-per-inch used in PCL dot moves is determined
by the current setting of the Unit of Measure command (see "Unit of
Measure Command" in Chapter 4).
14-4 PCL Rectangular Area Fill Graphics
E
* c # V
C
# =Number of decipoints (1/720 inch)
= 0
= 0 - 32767 valid to 4 decimal places
E
* c # B</BLD
C
# =Number of PCL Units
= 0
= 0 - 32767
E
*c600A
C
EN