Adaptive Compression (Method 5) - HP PCL 5 Reference Manual

Adaptive Compression (Method 5)

Adaptive compression enables the combined use of any of the four
previous compression methods (0 through 3), and it includes the
ability to print empty (all zeros) rows or to duplicate rows.
Adaptive compression interprets a raster image as a block of raster
data rather than as individual rows. The result of this interpretation is
that the Transfer Raster Data (
at the beginning of a raster data transfer, and the value field (#)
identifies the number of bytes in the block (all rows). For the other
compression methods, the Transfer Raster Data command is sent at
the beginning of each row and the value field (#) identifies the number
of bytes for that row only.
The size of a block is limited to 32,767 bytes. (32,767 bytes is the
number of compressed bytes and not the size of the uncompressed
data). To transfer greater than 32,767 bytes, send multiple blocks.
Adaptive compression uses three control bytes at the beginning of
each row within the block. The first of these bytes, the command byte,
identifies the type of compression for the row. The two following bytes
identify the number of bytes or rows involved. The format for adaptive
compression raster rows is shown below:
<command byte><# of bytes/rows - upper byte><# of bytes/rows - lower byte> ...
...<first raster row byte>...<last raster row byte>
The command byte designates the compression method, empty row,
or row duplication. Command byte values are shown below.
Table 15-9
Value
0 -
1 -
2 -
3 -
4 -
5 -
EN
E
*b#W
C
Compression Operation
Unencoded
Run-Length Encoding
Tagged Image File Format (TIFF) rev 4.0
Delta row
Empty row
Duplicate row
Set Compression Method Command 15-25
) command is sent only once