Attaching/Disconnecting The Battery Pack To/From The Appliance; Operation; Selecting A Tool; Tool-Changing - Parkside PABH 20-Li B2 Translation Of The Original Instructions

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the rotation direction switch
middle position (lock). Allow the battery pack
to click into the handle.
Removing the battery pack:
♦ Press the release button
battery pack .

Operation

NOTE
► Push the rotation direction switch
the middle position before carrying out
any work on the power tool (e.g. mainten-
ance, tool-changing, etc.) as well as during
carriage and storage of the power tool.
Unintentional activation of the On/Off
switch can result in injury.

Selecting a tool

■ For hammer drilling, you will need an SDS-plus
drilling tool.
■ For standard drilling in wood, metal, ceramics
and plastic, you can use an appropriate SDS-
plus drilling tool or a tool with a hexagonal
shank.
■ For screwing, use the screwdriver bits
you can attach using the SDS bit adapter

Tool-changing

■ You can use the SDS-plus tool holder
change tools quickly and easily without the
need for any additional tools.
■ The SDS-plus drilling tool moves freely (depend-
ing on the system). This leads to a radial run-out
deviation while idling. This has no effect on the
accuracy of the drill hole as the drill centres
itself during drilling.
PABH 20-Li B2
into the
and remove the
into
that
.
to
■ The SDS-plus bit adapter
ferent types of drills with hexagonal shanks.
■ The dust protection cap
entry of drilling dust into tool holder
operation. Ensure that the dust protection cap
does not get damaged when fitting tools.
NOTE
► A damaged dust protection cap
be replaced immediately. We recommend
having this done by a customer service
workshop.

Fitting an SDS tool

♦ Insert the tool rotatingly into the tool holder
until it clicks into place.
♦ Check that the tool is properly locked by pulling it.
The system has radial play because of the design.

Removing an SDS tool

♦ Pull the locking sleeve
move the tool.

Fitting a tool with a hexagonal shank

♦ Insert the SDS bit adapter
until it clicks into place.
♦ Check that the SDS bit adapter
locked by pulling it. The SDS bit adapter
radial play because of the design.
♦ Pull the locking sleeve
backwards and insert the tool with the hex-
agonal shank in the tool holder
♦ Release the locking sleeve
adapter . This locks the holder. Check that
the tool with the hexagonal shank is properly
locked by pulling it. The tool with the hexagonal
shank has radial play because of the design.
Removing a tool with a hexagonal
shank
♦ Pull the locking sleeve
the tool with the hexagonal shank.
can also hold dif-
largely prevents the
during
must
backwards and re-
into the tool holder
is properly
has
of the SDS bit adapter
.
of the SDS bit
backwards and remove
GB │ IE │
21 ■