Prestart Checklist; Raising The Mast - Generac Power Systems MLT3060MV Owner's Manual

Operation

Prestart Checklist

Before starting the unit, all items in the prestart check-
list must be completed. This checklist applies to both
manual and remote starting of the unit.
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.

Verify all maintenance procedures are up to date. For
more information, refer to
Basic Maintenance

The unit must be level.

The unit must be dry. Look for water inside or near
the unit; dry if needed.

For grounding requirements, follow the National
Electrical Code (NEC), state, and local regulations.

Verify Control Power switch is in the OFF (O) position.

Verify all circuit breakers are in the OFF (O) position.

Inspect all electrical cords; repair or replace any that
are cut, worn, or bare.

Verify all winch cables are in good condition and
centered on each pulley. Do not use if cables are
kinked or beginning to unravel.

Check oil, coolant, and fuel levels. For more
General
information, refer to

Verify battery connections are secure.

Turn the battery disconnect switch on, if equipped.

Check the engine fan belt tension and condition.

Check the engine fan belt guard.

Check exhaust system for loose or rusted components.

Verify all covers are in place and secure.

Raising the Mast

1. Set up and level the unit. See
DANGER
Electrocution. DO NOT use the unit if
electrical cord is cut or worn through. Doing
so will result in death or serious injury.
WARNING
Tipping hazard. Extend the outriggers and level the unit
before raising the mast. Keep the outriggers extended while
the mast is up. Failure to do so could cause the unit to tip
and fall and could result in death or serious injury.
14
(000100a)
General Maintenance
Schedule.
Maintenance.
Light Tower Setup.
(000263a)
(000266)
and
A
D
Figure 3-2. Raising the Mast
Figure
2. See
excessive wear or damage. Verify cables are
properly centered in each pulley (A). Check the
electrical cord for damage.
3. Press and hold the winch control toggle switch (B)
upward to telescope the mast to the desired height.
Extend the mast slowly, verifying that the coiled
electrical cord is extending at the top sections of
the mast. Do not extend past the colored mark (C).
IMPORTANT NOTE: Contact a GMASD immediately
if the mast hangs up or the winch cable develops
slack.
4. The mast can be rotated by loosening the mast
rotation knob (D). Turn the mast until the lights face
in the desired direction and then tighten the knob.
DETAIL B
DETAIL C
C
3-2. Check both sets of mast cables for
Owner's Manual for Mobile Light Tower
STOP
B
004557