Local Management - TP-Link TL-WR841N User Manual

Chapter 4
• Packets Statistics Interval (5~60)
60 seconds from the drop-down list. The
time section of the packets statistics. The result of the statistics is used for analysis by
SYN Flood, UDP Flood and ICMP-Flood.
• DoS Protection
disable the DoS protection function. Only when it is enabled, will the flood filters be
enabled.
Note:
Dos Protection will take effect only when the Statistics in
• Enable ICMP-FLOOD Attack Filtering
• ICMP-FLOOD Packets Threshold (5~3600)
between 5 ~ 3600. When the number of the current ICMP-FLOOD packets is beyond
the set value, the router will startup the blocking function immediately.
• Enable UDP-FLOOD Filtering
• UDP-FLOOD Packets Threshold (5~3600)
between 5 ~ 3600. When the number of the current UPD-FLOOD packets is beyond
the set value, the router will startup the blocking function immediately.
• Enable TCP-SYN-FLOOD Attack Filtering
function.
• TCP-SYN-FLOOD Packets Threshold (5~3600)
between 5 ~ 3600. When the number of the current TCP-SYN-FLOOD packets is
beyond the set value, the router will startup the blocking function immediately.
• Ignore Ping Packet From WAN Port
ping packet from the Internet cannot access the router.
• Forbid Ping Packet From LAN Port
ping packet from LAN cannot access the router. This function can be used to defend
against some viruses.
3. Click Save.
4. Click
4. 8. 3.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to
accessing the router.
Downloaded from ManualsNet.com
- Denial of Service protection. Select Enable or Disable to enable or
- Check the box to enable or disable this function.
Blocked DoS Host List to display the DoS host table by blocking.

Local Management

Security > Local Management, and you can block computers in LAN from
search engine
- The default value is 10. Select a value between 5 and
Packets Statistics Interval
System Tool > Statistics
-Check the box to enable or disable this function.
- The default value is 50. Enter a value
- The default value is 500. Enter a value
-Check the box to enable or disable this
- The default value is 50. Enter a value
- The default setting is disabled. If enabled, the
- The default setting is disabled. If enabled, the
Configure
value indicates the
is enabled.
44