Dhcp; Dhcp Settings - TP-Link TL-WR841N User Manual

Chapter 4
•
•
Note:
The range of bandwidth for guest network is calculated according to the setting of Bandwidth Control on the
Bandwidth Control
4. 6.
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the
router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices
from the IP Address Pool. You can change the settings of DHCP Server if necessary, and
you can reserve LAN IP addresses for specified client devices.
4. 6. 1.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to
3. Specify DHCP server settings and click Save.
• DHCP Server
DHCP server within your network or else you must configure the computer manually.
• Start IP Address
assigning IP addresses. 192.168.0.100 is the default start address.
• End IP Address
IP addresses. 192.168.0.199 is the default end address.
• Address Lease Time
will be allowed to connect to the router with the current dynamic IP Address. When
Downloaded from ManualsNet.com
Wireless Security - You can configure the security of the guest network.
Access Time - During this peroid the wireless devices can access the guest
network.
> Control Settings

DHCP

DHCP Settings

DHCP > DHCP Settings.
- Enable or disable the DHCP server. If disabled, you must have another
- Specify an IP address for the DHCP Server to start with when
- Specify an IP address for the DHCP Server to end with when assigning
- The Address Lease Time is the amount of time a network user
search engine
page.
Configure
35