Configuring The Users; Configuring The Communicator; Maintenance - INIM Electronics PREVIDIA COMPACT Manual

Configuration manual
3.8

Configuring the users

Tapping on the appropriate icon inside the control panel configuration screen accesses the configuration
section of the control panel access codes.
This section provides the list of available codes.
Once a code is selected, you can remove it from the
system by pressing the Delete button.
Instead the Program button will allow you to set its
parameters:
• Description, label that identifies the user and that is
shown in the events it is involved in.
• PIN, 5-figure number that identifies the user,thus allowing
access to the system.
• Type, determines the set of operations the user can
control. The following values are possible (refer to
paragraph 1.4 and the User manual):
- No code, code not enabled to access the system.
- User level, coincides with "Level 2" (authorized user)
- Superuser level, same as the previous one, with the
added possibility of replacing a loop device and
registering control panels to their account with the Inim
Cloud service
- Maintenance operator level, same as the previous level
with the added possibility of stopping the valve pulse
for those models that support extinction functions
- User level, coincides with "Level 3" (authorized user)
Previdia Compact control panels are supplied at default with
the first 4 codes already pre-set:
3.9

Configuring the communicator

To set the network parameters you must first enter the control panel programming phase (paragraph 2.2) and
then tap on the appropriate icon inside the control panel configuration screen.
The boxes marked [A] will allow you to select the
communication channels you want to use:
• Ethernet, for transmission of events with the SIA-IP
protocol over Ethernet cable
• PREVIDIA-C-DIAL, for transmission through the optional
communicator of the Previdia Compact.
If selected, the following channels will also become
available:
• SIM (SIA-IP), for transmission of events with the SIA-IP
protocol over 3G
• SIM (Voice/SMS), for transmission of events with
Contact-ID protocol, of voice messages or SMS texts
over 3G
• PSTN, transmission of events with Contact-ID protocol or
voice messages over the landline
System Parameters
Code number
1
2
3 Maintenance level
4
5 ...
No. Type
1 User level
2 Superuser level
3 Maintenance level
4 Installer level
5 No code
6 No code
Delete Program
Access level:3
Code parameters
Code 2
***** PIN
User level
Access level:3
Code type
User level
Superuser level
Installer level
No code
Ethernet
A
PREVIDIA-C-DIAL
SIM (SIA-IP)
SIM (voice/SMS)
PSTN
PREVIDIA-C-COM Program
Access level:3
Description
Code 1
Code 2
Code 3
Code 4
Code 5
Code 6
Description
Type
Default PIN
00001
00002
00003
00004
/
APN
B
Esc
Esc
Set
C
Contacts
Actions
D
Esc
Contacts
17