Table of Contents
Advertisement
Figure 73. Installing the filler bracket
NOTE:
Filler brackets must be installed over empty expansion card slots to maintain FCC certification of the system.
The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
Next step
1
Install the expansion card on the system board
Related link
Installing expansion card on the system board
Installing expansion card on the system board
Prerequisite
1
Follow the safety guidelines listed in
Steps
1
Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2
If you are installing a new card, remove the filler bracket.
a
Pull and lift up the expansion card retention latch lock to open.
b Pull the filler bracket upward out of the system.
120
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
