Tele Radio T9-02 User Instructions page 37

End user instructions│ T9/T11│ Chapter 10: Regulatory information
device. Therefore, the outside of the device into which the module is installed must
also display a label referring to the radio module. The final end device must be
labelled in a visible area with the following:
"Contains FCC ID: ONFC1108B"
"Contains IC: 4807A-C1108B"
Or
"Contains FCC ID: ONFC1203B"
"Contains IC: 4807A-C1203B"
1 0 . 2 . 2 I C S T A T E M E N T
This product complies with Industry Canada's licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
1. l'appareil ne doit pas produire de brouillage;
2. l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
To satisfy IC RF exposure requirements, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during
device operation. To ensure compliance, operations at closer than this distance is
not recommended.
Afin d'assurer la conformité aux exigences de la IC en matière d'exposition aux RF,
une distance de séparation d'au moins 20 cm doit être maintenue entre l'antenne
de cet appareil et toute personne à proximité pendant le fonctionnement de
l'appareil. Pour assurer le respect de ces exigences, il n'est pas recommandé
d'utiliser l'appareil à une distance inférieure à celle-ci.
The radio module in this product is labelled with its own FCC ID and IC number.
The FCC ID and IC is not visible when the radio module is installed inside another
device. Therefore, the outside of the device into which the module is installed must
also display a label referring to the radio module. The final end device must be
labeled in a visible area with the following:
ED-TG2-TX102-EN-v02 37