Table of Contents
Advertisement
Can't access the router
Ensure the computer is connected to the router router via an Ethernet
•
cable, or via the default Wireless Network Name as printed on the belly
label (if available).
•
Ensure that the computer and router or both connected to a power
source and powered on.
Ensure that the LEDs are displaying normally (refer to the LED
•
Troubleshooting section of this guide).
•
Ensure the computer is obtaining an IP address from the router, or that the
computer is on the same network as the router (default network is
192.168.1.0/24).
•
If the router is not using default settings, and you are not sure what the
settings are, you can hold in the hardware reset button on the back of the
unit for ~10 seconds (until the POWER light turns red and starts blinking) to
reset the unit back to factory defaults.
© 2020
83
Advertisement
Table of Contents
