HP xw3400 User Manual page 124

Figure 6. Creating a RAID Device
12. Choose a mount point, file system type, device, and RAID level for this partition.
Figure 7. Creating a RAID Device
13. Click OK.
14. Continue with setup as normal.
The Red Hat Enterprise Linux Anaconda installer only supports RAID-0, RAID-1, and RAID-5. Other
levels or nested RAID must be configured manually after installation. If you are creating a nested
RAID array, you can either configure the "bottom" RAID level (for example, the RAID-1 array in
the case of nested RAID-10) in Anaconda and the "top" RAID level manually later, or configure
both parts of the nested RAID level manually after installation.
HP only provides support for software RAID-0, -1, -5, and -10.
10