Advertisement
Installation
1. Remove battery cover by inserting a flat screw driver into the opening
recess and insert, in accordance with the markings, 4 new and
identical size AA 1.5 volt high quality Alkaline batteries, close cover.
Note: Please dispose of used batteries in accordance with local waste
regulations.
2. Place control unit holder on the base of the cot and in between two
bars as shown in illustration 1.
3. Sensor pad installation:
• When using for infant not yet able to crawl, place one sensor pad as
shown in illustration 2. Make sure the sensor is placed underneath
baby's location in crib.
• When baby begins to crawl, and is able to move onto areas not
"covered" by a single sensor pad, attach the second sensor and place
the two sensors as shown in illustration 2.
Control unit holder
Cables
Sensor
Sensor
I
llustration 1
Installation
5
Advertisement
