Table of Contents
Advertisement
5
Insert the wire into hole.
If you come up against an obstacle during
insertion, move the wire gently backwards
and forwards and/or press once or twice the
control switch to pivot the tying head and to
keep the wire moving through the machine.
6
Keep on feeding the wire through until it emerges from the tying head.
If the wire still doesn't come out: we recommend that you disconnect the tying head (see
chapter "Operating problems" P17), check that the wire isn't stuck and try to insert it with
the head removed.
7
Unclip the brake system lever.
At the start of each reel, check that the wire
is properly rolled and doesn't stick between
cheeks.
Switch the machine on and press
8
briefly on the control switch to cut
the excess wire.
You can now start tying operations.
9
Advertisement
Table of Contents
